This means the unit is restarting. If this happens over and over again, ensure the mains power supply is on and allow the battery to charge for another 2-3 hours. If the restart beep continues, the battery will need to be replaced. This is usually caused by someone allowing the battery to drain completely flat without mains power.
Articles in this section
- I have an SR on my AlertMaxx2, what does it mean?
- How do I wire an AwareMaxx into an AlertMaxx2 or Rego1?
- How do I wire in a 6V beacon into the AlertMaxx2 or Rego1?
- Are stepping relays covered under warranty?
- How much voltage goes down the AlertMaxx2 float?
- What do the LED codes mean on my AlertMaxx?
- How do I connect to the Rego1 volt free relay?
- When installing my AlertMaxx2, I get a constant F1 code, why?
- How do I install a Dual V3, AlertMaxx2 and PowerMaxx2?
- What type RCBO should I use?