FAQ's
- I have an SR on my AlertMaxx2, what does it mean?
- How do I wire an AwareMaxx into an AlertMaxx2 or Rego1?
- How do I wire in a 6V beacon into the AlertMaxx2 or Rego1?
- Are stepping relays covered under warranty?
- How much voltage goes down the AlertMaxx2 float?
- What do the LED codes mean on my AlertMaxx?
- How do I connect to the Rego1 volt free relay?
- When installing my AlertMaxx2, I get a constant F1 code, why?
- How do I install a Dual V3, AlertMaxx2 and PowerMaxx2?
- What type RCBO should I use?
- Does the AlertMaxx2 require a separate supply to power it?
- Does the AlertMaxx2 and PowerMaxx2 have to be put in a fire proof cupboard?
- How do I swap my current AlertMaxx wiring to install an AlertMaxx2?
- What does an F3 mean on the AlertMaxx2?
- What do the error and configuration codes mean on a PowerMaxx2?
- Why does my Rego1 control panel show UC?
- I have a P2 on my AlertMaxx2/Rego1, how do I mute it?
- What does F1 mean on an AlertMaxx2/Rego1?
- What does E8 mean on an AlertMaxx2/Rego1?
- What does E7 mean on an AlertMaxx2/Rego1?
- What does E5 mean on an AlertMaxx2/Rego1?
- What does E4 mean on an AlertMaxx2/Rego1?
- What does E3 mean on an AlertMaxx2/Rego1?
- What does E2 mean on an AlertMaxx2/Rego1?
- Where does the PowerMaxx2 need to be installed and how big is it?
- Do your battery backups operate on both sumps i.e. ground water and foul water?
- Commercial Services Brochure
- Domestic Servicing Brochure
- How do I adjust the float arm on a V3, V4, V6 pump?
- How do I install and setup the blue finger float on my AlertMaxx2?